CameraTransmitterHacks & Mods
Fresh Goop - Air Dry Epoxy applied to perimeter of newly installed CF-plywood sandwich
Vertical steel rod straightened to easily slide up and down on CF-plywood plate
Carbon Fiber sandwich to birch 3/32 plywood in two part epoxy now attached through plastic guide supporting nose wheel.
View into LiPo battery compartment - Carbon fiber plywood sandwich now epoxied to side panel to reinforce side walls and increase ability to handle centrifugal force.
Plan View - top down perspective into nose section of Botmite-1
View through camera bay of nose wheel strut of fresh set CF-ply support
Plan View (top down) - Nose wheel strut and steering
Looking into UAV aircraft over the timely installation of the nose wheel strut.
Crunch Time - 15 August 2013
Evaluating another wing for Botmite-1 to handle more weight with the existing uav platform.
Repair 1Repair 3Repair 4Repair 5Repair 6calcs & toolsWing of Botmite 1.1A 8ft.